Outdoor gas fireplace kits using one of two basic ignition systems, depending on the age of the appliance. Older gas stoves can use a ceramic-type electrode spark ignition system similar to that used on the outdoor gas grill. Newer fireplaces works with an electronic ignition system with a modular plug to be connected to a power source, usually a 9-volt battery. Test both systems takes only minutes.
Turn off the gas stove and wait for it to cool before you troubleshoot the lighter. Close the gas valve in the tube that is connected to the outdoor gas fireplace kits. Remove the access plate with a screwdriver. Clean the L-shaped connector on the end of a ceramic igniter electrode with a piece of steel wool. Press the ignition button to watch for a spark at the electrode tip.
Push the plug into the end of the cable from the push button unit on the plug of the lighter and test again. If your device only, click but not spark igniter is probably worn out and should be replaced. Continue troubleshooting to test an electronic system. Replace the battery in the battery pack under the control panel of an electronic ignition system with a fresh 9-volt battery.
Press the ignition button. If the lighter does not produce a spark near the burner, continue troubleshooting in the outdoor gas fireplace kits. Pull the mains plug at the end of the lighter from the socket on the battery. Hold the two probes of the ohmmeter to the two contacts of the connector at the end of the lighter. If the ohm meter reads zero, the igniter is defective and must be replaced.fireplace kits, troubleshooting gas fireplaces, outdoor patio fireplace kits, outdoor gas fireplace kits, outdoor gas fireplace, ohmmeter lowes, troubleshoot gas fireplace, gas fireplace lighter, fireplace ignition systems, gas fire pit components, fireplace igniter repair, small outdoor fireplace kits, patio glow fire pit parts, gas fireplace troubleshooting, fireplace plug home depot, modern outdoor fireplace kits, gas fireplace ignition systems